Continuous Recording - Abus TVIP21502 Manuel Utilisateur

Action
The following actions can be defined within an event action. Not all actions are available with all triggers. For
an activation, it is necessary to check the box of the action, but it is also possible that other boxes need to be
checked for further configuration of the action.
Send image(s):
Send notification:
Activate switching output:
Night mode:
Schedule
Always: The event action is always executed without a time-based restriction.
Schedule: Here a schedule that has already been configured can be selected for the event action.
Schedules are configured under the "Event / Schedule" item.

6.6.3 Continuous Recording

Scheduled recording can be used only for recordings of video files.
Name: Name of the configured event
Active: Shows whether the event is enabled.
Action: Information about the action that follows after the event is triggered
NS: Network storage (network drive)
LS: Local storage (SD card)
Schedule: Schedule of the event action
General
Name: Enter a name for the scheduled recording here.
Select the required event server that has already been configured.
This action sends a notification to an HTTP server. The option HTTP server
needs to be configured beforehand.
Select the switching output. The switching behavior also needs to be
configured:
Constantly active during event triggering: While the trigger is triggered (such as
through an extended period of motion detection), the switching output remains
activated.
Constantly active for: The switching output can be activated for 1–999 seconds.
Night mode of the camera is activated. The switching behavior also needs to
be configured:
Constantly active during event triggering: While the trigger is triggered (such as
through an extended period of motion detection), night mode remains
activated.
Constantly active for: Night mode can be activated for 1–999 seconds.
112