X-lite X-803 RS Sécurité Et Instructions D'utilisation page 28

X803 RS
WARNING
- Check that the side flaps are correctly fastened to the support by gently pulling
their ends outwards and ensuring that they do not detach from the support.
- Check that the top flap is correctly fastened to the support by sliding it back and
forth (Fig. 40), and pull it slightly outwards to check that it does not detach from
the support.
3 DISASSEMBLING THE TOP FLAP
3.1 Push the top flap of the ASD forwards as far as it will go (Fig.40).
3.2 Pull one side of the top flap outwards until the lower tooth is released from the
guide on the support affixed to the shell. Repeat on the other side (Fig.42).
3.3 Pull the middle of the top flap outwards to completely remove it from the support
affixed to the shell (Fig.41).
4 DISASSEMBLING THE SIDE FLAPS
4.1 Push the lower end of the left side flap of the ASD towards the back of the helmet
until the grip pawl is released from the side seat on the upper support affixed to
the shell (Fig.43).
4.2 Repeat on the other side of the helmet to release the right side flap from the helmet.
28
INSTRUCTIONS FOR USE