Maintenance And Cleaning - X-lite X-803 RS Sécurité Et Instructions D'utilisation

X803 RS
2 CHECKING AND ADJUSTING THE PINLOCK® INNER VISOR STRETCH
Check the correct PINLOCK
and making sure that they do not move.
If the PINLOCK inner visor is not tightly fixed to the visor, simultaneously move both
®
external adjustment levers upwards to increase the stretch (Fig.8). This operation must
be carried out gradually. The maximum stretch is achieved when the pin adjustment
external levers are turned outwards.
WARNING
- The presence of dust between the two visors may produce scratches on both
surfaces.
- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform any following adjustments.
- Intense sweating/breathing, the use under particular weather conditions (low tem-
peratures, high humidity, sudden changes in temperature or heavy rain) or intense
and prolonged use may affect the performance of the PINLOCK
cause fogging or formation of condensation. In such cases, to restore the sys-
tem efficiency after using the helmet, remove the PINLOCK
helmet visor and let it dry with dry and warm air. The same procedure must be
applied to the helmet, in order to dry out humidity in case it has formed up as a
consequence of the conditions described above.
3 PINLOCK INNER VISOR DISASSEMBLY
®
3.1 Remove the visor equipped with the PINLOCK
3.2 Widen the visor and release the PINLOCK
3.3 Release the visor.
4

MAINTENANCE AND CLEANING

- Remove the PINLOCK
gently clean it with neutral liquid soap. Remove the soap under running water.
- Dry the visor with dry and warm air without wiping it.
- To keep the features of the visor in good conditions over time, let the helmet dry
in a ventilated and dry place with the visor open after use. Keep it away from heat
sources and store it in a place away from direct light.
- Do not use solvents or chemical products.
REMOVABLE INNER COMFORT PADDING
The removable comfort padding consists of:
- a liner
- pads of the side cheek pads (right and left)
20
INSTRUCTIONS FOR USE
inner visor assembly by opening and closing the visor
®
visors and inner visors may cause reduced visibility and
®
inner visor is both correctly assembled and stretched.
®
inner visor from the visor. Using a damp and soft cloth,
®
inner visor to prevent it from
®
inner visor may result in exces-
®
inner visor (see instructions above).
®
inner visor from the pins (Fig.10).
®
inner visor and
®
inner visor from the
®