X-lite X-803 RS Sécurité Et Instructions D'utilisation page 21

- strap covering
All components can be completely removed and washed. The cheek pads are also
characterised by removable inner expanding foam padding.
1 CHEEK PAD DISASSEMBLY
1.1 Unfasten the chin strap (see relevant instructions).
1.2 Gently pull the red strap in the front area of the pad of the left cheek pad to release
the safety lever on its back (Fig.11).
1.3 Hold the front part of the pad of the left cheek pad and turn it upwards to unhook
the front and upper hooks on its back (Fig.12).
1.4 Pull the back of the pad of the left cheek pad towards the inside of the helmet to
undo the snap fastener on its back (Fig.13).
1.5 Pull the front part of the left cheek pad base upwards until the front fastening "A"
of the frame releases from its corresponding plate between the outer shell and the
polystyrene cheek pad (Fig.14).
1.6 Completely remove the helmet left cheek pad, by flapping the pad base frame out
of the cavity between the outer shell and the polystyrene cheek pad.
Do not remove the polystyrene cheek pads from the helmet shell.
2 DISASSEMBLY OF THE INNER EXPANDING FOAM PADDING OF THE CHEEK PADS
To make it easier to wash the inner comfort padding components, the cheek pads of
the helmet are fitted with inner expanding foam padding that can be removed from the
fabric lining. To remove the padding, proceed as follows after removing the cheek pads
from the helmet (see instructions above).
2.1 Gently remove the inner expanding foam padding from the fabric lining of the left
cheek pad (Fig.15).
2.2 Repeat these steps with the right cheek pad padding.
WARNING
- Once the inner paddings of the cheek pads in expanding foam have been re-
moved, make sure that the back snap button "D", the fastenings "A" and the
NERS safety lever "B" are correctly fastened to the rear frame of the fabric lining
of the cheek pads(Fig.16). Otherwise, correctly put them back.
3 DISASSEMBLY OF THE CHIN STRAP COVERING
To remove the chin strap covering from the strap, proceed as follows after removing the
cheek pads from the helmet (see instructions above).
3.1 Pull the left covering strap in line with the "hook and loop fastener" to separate it
from the chin strap band and then take it off (Fig.17A).
3.2 Repeat these steps with the right covering strap.
4 LINER DISASSEMBLY
4.1 Release the left rear flap of the liner from the shell rear edge by slightly puling the
comfort padding towards the inside of the helmet (Fig.18). Follow the same steps
for the right rear flap.
X803 RS
INSTRUCTIONS FOR USE
21