X-lite X-803 RS Sécurité Et Instructions D'utilisation page 23

8 CHEEK PAD ASSEMBLY
WARNING
- Take the pad of the left cheek pad and make sure that the back snap button "D",
the fastenings "A" and the NERS safety lever "B" are correctly fastened to the
back frame of the fabric lining of the cheek pad (Fig.16).In addition, check that the
NERS lever is free to turn; then, place the lever in the opening position.
8.1 Insert the rear guide "C" of the pad base frame between the outer shell and the
polystyrene inner shell. Then, pull the rear guide of the pad base frame downwards
and insert it in its corresponding cavity between the outer shell and the inner pol-
ystyrene cheek pad (Fig.23).
8.2 Press the lower part of the left cheek pad to hook the front fastening "A" to its cor-
responding plate between the outer shell and the polystyrene cheek pad (Fig.14).
Then, make sure the pad base frame is correctly placed under the shell edge trim.
8.3 Insert the chin strap in the passageway of the cheek pad padding and press near
the rear snap fastener placed on the back to fasten it to the relevant seat on the
polystyrene cheek pad (Fig.13).
8.4 Press the pad of the left cheek pad against the polystyrene cheek pad and at the
same time turn it inwards to fasten the front and top hooks on its back. (Fig.12).
8.5 Press the safety lever upwards in line with the fastening area of the red strap to
turn it towards the cheek pad padding until it reaches its closing position. (Fig.11).
8.6 Check that the fastener and hooks are firmly fastened by slightly pulling the pad of
the cheek pad towards the inside of the helmet, then check that it remains adher-
ent to the polystyrene cheek pad.
Warning: the buttons are not fastened until a click is heard. Check that the strap
comes out properly from the cheek pad padding.
8.7 Repeat these steps with the right cheek pad padding.
WARNING
- If your helmet is equipped with the double D-Ring retention system, pull it
down as indicated in the attached double D-Ring label.
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet if all parts of the inner comfort padding have not been cor-
rectly and completely reassembled.
- Delicately hand-wash in lukewarm water (max. 30° C) and neutral soap.
- Rinse with cold water and allow drying at room temperature, away from direct
sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the helmet's internal polystyrene components in any way.
- Clean the inner polystyrene components with a damp cloth only and allow it to dry
at room temperature away from direct sunlight.
- Never use tools or equipment of any sort to carry out the steps described above.
X803 RS
INSTRUCTIONS FOR USE
23