Fader; Setting The Balance; Linear Setting; Setting The Subwoofer Or Centre Speaker Volume - Sony MEX-100NV Mode D'emploi

7890_GB.book Seite 79 Montag, 1. Juli 2002 1:20 13

Fader

Press SOUND and then the multifunction button
F a d e r 0
FM
BasTrb Fad Bal Flt Sub Ldn
Use the SELECT control for the desired fader setting.

Setting the balance

Press SOUND and then the multifunction button
B a l a n c e 0
FM
BasTrb Fad Bal Flt Sub Ldn
Set the desired balance level using the SELECT control.

Linear setting

Briefly press SOUND.
T o n e f l a t ?
FM
BasTrb Fad Bal Flt Sub Ldn
Press the multifunction button
.
Fad
played. By pressing the multifunction button
tone settings for the currently selected signal source (e.g. FM)
are set to an average value.

Setting the subwoofer or centre speaker volume

Press SOUND and then the multifunction button
S u b w o o f e r 0
FM
BasTrb Fad Bal Flt
.
Bal
Use the SELECT control to set the desired subwoofer volume
level.

Switching loudness on / off

Press SOUND and then the multifunction button
L o u d n e s s O N
FM
BasTrb Fad Bal Flt Sub
Using the multifunction button
loudness on ( ) or loudness off (
ON
Loudness is switched off in MW, LW and SW wavebands.
General operation
- Tone flat is dis-
Flt
again the
Flt
.
Sub
Sub Ldn
.
Ldn
Ldn
you can select either
Ldn
).
OFF
79