Storing A Specified Destination In The; Destination Memory - Sony MEX-100NV Mode D'emploi

7890_GB.book Seite 91 Montag, 1. Juli 2002 1:20 13
Further information under "Dynamic navigation with
TMC" on page 98.
•
RESTRICTIONS
Provides options for avoiding motorways, ferries or toll
roads.
MOTORWAY W WITH / WITHOUT
FERRIES WITH /
TOLL WITH /
Selection can be made by turning the SELECT control,
and settings can be changed by pressing the SELECT con-
trol.
Press the control for more than 2 seconds to accept all set-
tings and quit the menu.
Note: Routes without motorways can only be calculated
for short distances (up to 200 km).
Storing a specified destination in the destination
memory
It is not absolutely necessary to store a destination in the des-
tination memory for route guidance. It saves repeated manual
entry, if the destination is required at a later date.
Select
SELECT control to confirm.
WITHOUT
WITHOUT
NAME:
ABCDEFGHIJKLMNOPQRSTUVWXYZ
#$" ! 0123456789,/() .
Any name of your choice consisting of up to 20 characters can
be entered for the specified destination and then automatically
stored in the destination memory after pressing the SELECT
control for more than 2 seconds. See "Destination memory"
on page 104.
To store, the small tick
LECT control briefly pressed.
If you do not wish to enter a name of your choice, press and
hold the SELECT control for more than 2 seconds to store the
address as previously entered in the destination memory.
The last destination entered can be filed at any position by
turning the SELECT control. The memory position is con-
firmed by briefly pressing the SELECT control.
A total of 50 destinations can be stored.
NEW DEST.
S T A R T - F A S T R .
ROUTE SETTINGS
Navigation operation
in the route menu and press the
SAVE DESTINATION
H
can also be selected and the SE-
91