Specifications; Mounting Precautions (For Sharp Dealers And Service Engineers) - Sharp PN-V551 Manuel D'installation

Model
Power requirement
Operating temperature *
Operating humidity
Power consumption (Maximum)
Dimensions (excluding protrusions)
Weight
* Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such
cases, please check the temperature condition specified by the optional equipments.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.
(For SHARP dealers and service engineers)
• When installing, removing or moving the monitor, ensure that this is carried out by at least 2 people.
• Be sure to use a wall-mount bracket designed or designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials
such as plaster / thin plastic board / wood before starting installation.
• This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor.
Install by the most suitable method for the material and the structure.
• To attach a VESA-compliant mounting bracket, use M6 screws that are 5/16 inch (8 mm) to 3/8 inch (10 mm) longer than the
thickness of the mounting bracket.
• Do not use an impact driver.
• When moving the monitor, be sure to hold it with the handles (do not hold the top, bottom, or sides of the monitor). Do not
hold the LCD panel. Also, do not orient the monitor so that the LCD panel faces the ground. This may cause product damage,
failure, or injury.
• When performing an installation where the monitor is stacked, please install it such that load is not placed on the monitor.
• After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount.
• Do not use any screw holes other than VESA holes for installation.
10
E

Specifications

PN-V551
AC 100 V - 240 V, 2.4 A, 50/60 Hz
32°F to 104°F (0°C to 40°C)
20% to 80% (no condensation)
210 W
inch (mm) Approx. 47-3/4 (W) x 4-1/2 (D) x 26-15/16 (H) (1213.5 x 113.8 x 684.3)
lbs. (kg) Approx. 60.2(27.5)
PN-ZR01A (optional): Approx. 0.220 (0.1)
Mounting Precautions
5/16 - 3/8 inch (8-10 mm)
Screws (M6)
Mounting bracket
Monitor mounting
PN-V550A
AC 100 V - 240 V, 2.1 A, 50/60 Hz
185 W
Approx. 55.1(25.0)