Specifications - Sharp LL-T1811W Mode D'emploi

Product specifications
LCD display
18.1 inches (46 cm measured diagonally)
Super-V and Anti Glare Low Reflection TFT LCD
module
Resolution (max.)
SXGA 1280 x 1024 pixels
Displayable colors (max.)
16.77 million colors (8 bit)
Brightness (max.)
2
200cd/m
Dot pitch
0.2805(H) 0.2805(V) mm
Contrast ratio
350:1
Angle of visibility
Left-right 150°; Up-down 150°
Screen display size
Horizontal 359 mm x Vertical 287.2 mm
Video signal
Analog: Analog RGB (0.7Vp-p) [75Ω]
Digital: DVI standard based on 1.0
Sync signal
Separate Sync (TTL level: +/-), Sync on
Green, Composite Sync (TTL level: +/-)
Expansion compensation
Digital screening (enlargement of display to
correct VGA/SVGA/XGA)
[1:1, expansion (fixed aspect ratio), expansion
(total screen surface)]
Plug & Play
VESA: DDC1/DDC2B compatible
Power management
VESA: based on DPMS
DVI: based on DMPM
Input signal terminal
Analog: 15 pin mini D-sub (3 rows)
Digital / Analog:29 pin DVI-I
USB hub function
1 upstream port, 2 downstream ports (bus-
powered hub based on USB standard Rev 1.1)
Screen tilt
Upward 0° -30°; downward 0° - 5°
Screen swivel
90° from left through right
Power supply
AC100-240V, 50/60Hz (Use special AC adapter,
type NL-A03E of Sharp Corporation.)
Temperature of operating environment
5 - 35°C
Power consumption
Maximum 44W (3.2W when in power-saving
mode)
(Use special AC adapter.)
Dimensions (W x D x H)
443 mm x 218 mm x 465 mm
Weight (excluding AC adapter)
Approx. 10.1 kg
Display area only, approx. 7.8kg

Specifications

Dimensions (Units: mm)
Length of analog signal cable: approx. 2.0 m*
Length of USB cable included: approx. 1.8 m
*Length from analog signal input terminal
Special AC adapter
Digital signal cable (NL-C01E):
Analogue signal cable (NL-C02E): Approx. 2.0 m
26
Approx. 2.0 m
Approx. H 120 mm x D 60 mm x H 35 mm
Approx. 2.0 m