13 – REMOVAL OF THE EGG TURNING UNIT FROM THE AUTOMATIC INCUBATOR
Follow the instructions below to remove the egg turning unit from the automatic incubator (art. 549/A), if necessary:
A)
Remove the egg tray. Lift it, pulling it out from the steel tongue of the egg turning unit.
B)
After having capsized the base of the
incubator, remove the two screws at the
bottom.
C)
Remove the screw inside the base of the incubator (extra screw present only in the
automatic model).
D)
Remove the egg turning unit.
WARNING
Do not open the egg turning unit by removing the four screws shown by the
arrows.
Opening the unit will cause its guarantee to be null and void.
14 – GUARANTEE
The guarantee is valid provided that the incubator is used for its intended use.
Apart from the ordinary and extraordinary maintenance described in the CLEANING section, to be carried out as described, any repair or
modification made to the appliance by the user or by unauthorized companies will cause the guarantee to be null and void.
The guarantee does not cover any damage caused by incompetence or negligence in the use of the incubator, or by bad maintenance, or lack
of it.
The products we sell are covered by guarantee at the following conditions:
1.
The guarantee is valid for a period of twelve/twenty four (12/24) months (12 months for firms, 24 months for private individuals).
2.
The producer undertakes to replace at its discretion the malfunctioning or wrongly manufactured parts, only after having thoroughly
checked them and having verified the fault.
3.
Transport and/or shipment costs are always at the purchaser's care.
4.
During the period of guarantee, all replaced products become the producer's property.
5.
Only the original buyer who fulfills the normal maintenance operations described in this manual can benefit from this guarantee. Our
responsibility on the guarantee expires when the original owner cedes the property of the product, or if it has been modified.
6.
The guarantee does not cover damages caused by excessive stress, such as in case the product is used after having ascertained an
anomaly or overheating of the motor, in case of improper use, and if the use and maintenance instructions are not observed.
46
NO