Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
D)
Ensure that the egg tray is in the correct position (on its supports) and that the cradle rows tilt freely in the two directions.
E)
Fill basin 5/a with lukewarm demineralized water. Pour the water into the
corresponding opening at the front left hand side of the incubator. Do this slowly, taking
care not to allow the water to overflow from the basin: too much liquid would increase
in the humidity rate lowering the hatching percentage. The second basin (5/b) will be
used only for the hatching phase.
You can top up the basin(s) even when the incubator is working. If possible, do this
when the incubator is unplugged, as although the appliance is designed not to be
damaged by water, inadvertent spillage can damage the electrical components.
F)
Replace the lid. Ensure that the edge of the lower box locates perfectly with the slot in
the lid.
G)
Insert the cover's plug into a suitable socket; the supply voltage of the electrical system
must be suitable for the incubator's voltage. Ensure that your hands are not wet while
performing this operation. The fan will start immediately, followed by the display that
shows the temperature inside the incubator. The LED indicates that the resistor is
working. It will remain illuminated for 20-40 minutes, until the set temperature is
reached; it will then flash intermittently at 2-3 seconds intervals.
WARNING:
IF THE FAN IMPELLER DOESN'T START, IMMEDIATELY UNPLUG
THE INCUBATOR AND CONTACT THE SERVICE CENTRE.
The machine is pre-set at a temperature of 37,7°C, ideal for all species of birds. It is recommended you reset the temperature following the
instructions here below.
If the writing ErtH or ErP1 appears on the display, unplug the incubator and forward it to the closest service centre.
39
Publicité
Table des Matières
