How To Operate The Squeegee And The Vacuum Motor; How To Operate The Solution Flow; How To Operate Brush Pressure; How To Operate The Forward / Reverse Switch - Clarke FOCUS 28 Disc Manuel D'utilisation

Masquer les pouces Voir aussi pour FOCUS 28 Disc:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
EN
How To Operate the Machine

How to Operate the Squeegee and the Vacuum Motor

The squeegee wipes the floor while the vacuum motor
removes the dirty solution from the floor. To operate the
squeegee, follow this procedure:
1. To lower the squeegee and start the vacuum motor,
press the squeegee up/down switch to the down
position (figure 24). NOTE: The vacuum motor will
start immediately when the down position of the
switch is pressed, and the squeegee will lower.
2. To raise the squeegee, press the squeegee up/down
switch to the up position (figure 24). The squeegee
will then raise and the vacuum motor will shut off after
short delay NOTE: The center position of the
squeegee up/down switch is for use with one
touch control.
NOTE: The squeegee will raise automatically when
traversing in reverse during scrubbing operations.

How to Operate the Solution Flow

The solution is used to loosen and remove dirt from the floor.
The amount of solution applied can be adjusted to five different
levels to accommodate many different floor conditions. These
different levels are shown on the LCD display on the front of the
machine. To adjust the amount of solution applied, use the
Solution Flow Switch (figure 25). NOTE: There are five
different settings on the display. See figure 26, A.
To increase solution flow:
1. Press the " + " side of the switch (figure 25).
2. Press and hold the " + " switch to achieve the desired level
of solution flow.
To decrease solution flow:
.
1. Press the " - " side of the switch (figure 25).
2. Press and hold the " - " side of the switch to achieve the
desired level of solution flow.
How to Operate the Brush Pressure
The brushes are used to supply agitation for the solution, which
improves the cleaning process. The amount of brush pressure
applied can be adjusted to five different levels to accommodate
many different floor conditions. These different levels are
shown on the LCD display on the front of the machine (figure
26, B). To adjust the amount of brush pressure, use the brush
up/down switch (figure 27).
To increase brush pressure:
1. Press the " + " side of the switch (figure 27).
2. Press and hold the " + " switch to achieve maximum level
of pressure.
To decrease brush pressure:
.
1. Press the " - " side of the switch (figure 27).
2. Press and hold the " - " side of the switch to achieve
minimum or no brush pressure.
Page
-18-
Figure 24
Figure 25
Figure 26
Figure 27
Clarke
®
Operator's Manual (EN) - Focus Rider
B
A

Publicité

Table des Matières
loading

Table des Matières