Snap-On EEWB333B Mode D'emploi page 37

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

E22
Speed low
The rotation speed of the wheel has not reached the
minimum limit needed to enable balancing.
Check that the brake (pedal) or wheel is not
accidentally blocked.
Check that something is not braking or ob-
structing the wheel.
Check the power supply.
Fit the wheel correctly.
Contact Technical Support at 800-225-5786.
E24
Velocity fl uctuations
If the speed of the wheel to keep to the need to com-
pensate.
• Check that the wheel is not obstructed or impeded
by something.
• Check the power supply.
• Fit the wheel properly.
• Call Technical Support at 800-225-5786.
E25
Reverse error.
The shaft is rotating at a certain speed but in the
wrong direction.
Apply the brake.
Contact Technical Support at 800-225-5786.
The display clears when rotation stops.
E26
No acceleration.
No shaft acceleration has been registered.
Contact Technical Support at 800-225-5786
E27
Slipping registered.
The wheel slips on the shaft.
Fit the wheel correctly.
E28
Speed limit reached.
Contact Technical Support at 800-225-5786.
E50
Manufacturer's calibration incomplete
Contact Technical Support at 800-225-5786.
E51
Calibration failed
Switch unit off, wait for 20 seconds.
Switch unit on.
Retry calibration, or:
Contact Technical Support at 800-225-5786
E52
The calibration weight is on the opposite side to the
calibration carried out by the manufacturer.
Fit the User Calibration Weight correctly on
the left side of the fl ange. Repeat Calibration.
Contact Technical Support at 800-225-5786
E82
Fault during self-test at start-up.
Switch unit off, wait for 20 seconds.
Switch unit on.
E92
During the second attempt the SAPE arm for distance
and rim diameter was still not in the home position.
SAPE arm is rendered inoperative.
Wait 5 seconds, or press the STOP key to
continue.
EEWB333B
37

Publicité

Table des Matières
loading

Table des Matières