Mode Selection; Weight Placement Modes; Motorcycle Mode - Snap-On EEWB333B Mode D'emploi

4.3 MODE SELECTION

The majority of balancing takes place in the default
2-plane dynamic mode which is displayed as "2 PL"
(location 1). Hammer-on clip weights will be placed
on both inside and outside of the rim edge. If required,
select an optional weight placement mode by pressing
the Mode button until the appropriate placement mode
is displayed.

4.3.1 WEIGHT PLACEMENT MODES

Before Spinning the wheel (although it may be done
afterwards) choose the appropriate balancing mode
for the wheel. To select the various placement modes
press the (9) Weight Placement button (Figure 14)
until placement LEDs (Figure 14a) indicate desired
placement positions.
Figure 14
Figure 14a
A. DYNAMIC (two planes), suggested for all steel rims.
In this case the wheel weights must be clipped onto the
rim edges. This function is selected as a default and
the LEDs corresponding to the wheel weight location
are lit on Figure 15.
Figure 15
B. STATIC (single plane - Figure 16). Suggested for
narrow rims (3" or less). Use a single corrective weight
placed in the center of rim as illustrated in Figure 16.
Figure 16
With purely static imbalance the center of gravity and
thus the principal axis of inertia of the wheel is not on
the axis of rotation.
14
Due to the unbalanced mass the wheel has a heavy
and light side related to the axis of rotation.
Static imbalance is compensated far by fi tting counter-
balance weights to the light side of the wheel, either in
the center or on the sides of the rim.
To select the STATIC Mode:
WEIGHT COMBINATION MODES USING THE
WEIGHT SELECTION BUTTON
See (Figure 14). Pressing the weight selection button
(9) will toggle the LED's to the weight default selections
as shown. Balancing using a combination of hammer-on
and adhesive weights as shown in Figure 17.
9
Figure 17

4.3.2 MOTORCYCLE MODE

When the Motorcycle Mode is active (keys 7-5, Fig.17a),
Figure 17a
only the following weight positioning options are available:
-
-
-
-
Note: The Easy Alu function is not available when the
Motorcycle Mode is selected.
To balance a motorcycle wheel:
•
•
•
•
•
•
Note: At the end deselect the Motorcycle Mode to make
all the weights positioning options and the Easy Alu
function available again.
EEWB333B
1. Touch the SAPE arm to the rim fl ange.
2. Enter the rim width dimension.
3. Press Alu button (9) four times.
7
Normal (clip – clip)
Static 1 (in the middle of the rim)
Static 2 (on the left side of the rim)
ALU 1 (stick – stick)
Install the Motorcycle adaptor EAA0260D80A.
Install the wheel.
Activate the Motorcycle Mode (7-5, Figure 17a).
Apply the SAPE extension, then Acquire/Set the
three wheel dimensions.
Perform the measuring run.
Select a Weight Mode (9 Figure 14) from the four
available.
5