Manual Parameter Entry; Manual Rim Diameter Entry; Manual Distance Entry; Easy Alu Function - Snap-On EEWB333B Mode D'emploi

4.5.3 MANUAL PARAMETER ENTRY

In the event of automatic measuring failure, the param-
eter values can be input manually. See manual entry of
rim width in the previous paragraph.
Figure 22
D
W
O
Figure 23

4.5.3.0 Manual Rim Diameter Entry

Select the Manual Diameter button. Read the rim di-
ameter marked on the sidewall of the tire (Figure 22
and 23). Press the Diameter Button (D) and enter the
measured rim diameter by selecting the +/- keys until
the desired value appears in the display.
Select Enter to save selection.
Figure 24

4.5.3.1 Manual Distance Entry

Move the distance SAPE arm to touch the inner edge
of the wheel where weights are to be placed and ob-
serve the reading on the graduated scale. See Figure
24. Press manual Wheel Offset button (O) followed
by selecting the +/- keys until value is displayed in the
display window.
Select Enter to save selection.
NOTE: The parameter arm must be in the Home rest
position when the balancer is powered up.
4.6

Easy Alu FUNCTION

The Easy Alu function automatically recognizes the
desired weight location by placing the SAPE arm in
the correct locations.
Note:
Alu Modes 4 and 5 are not operable in the Easy Alu
function. They require manual setting.
Note:
The Easy Alu is not available in Motorcycle MODE.
4.6.1 AUTOMATIC RIM DIMENSION
READING AND ALU P MODE SELECTION
Preparations:
— Compensation run carried out, if necessary.
— Wheel correctly clamped.
Important: The OK indication and recommendation
for optimization, as well as the optimization procedure
itself, will only be accurate if the rim width is correctly
entered (Manual Input).
Automatic rim distance and diameter reading with
SAPE arm
— Move the SAPE arm into position on the rim to select
the initial weight application position (internal rim side).
Keep it in this position until an audible signal is heard.
Figure 25
Only for Alu2P and Alu3P (Fig. 25):
— Position and hold the SAPE in the second position
on the rim to select the application position on
the right side of the rim.
Shortly afterwards the machine emits an audible
signal to indicate that the machine automatically
saves the weight application coordinates.
— Move the SAPE arm to the idle position.
At this point you can change the Alu mode suggested
by the machine, using the "Easy Alu Toggle" function.
Do this by pressing the button
— Spin the assembly.
EEWB333B
once.
17