Code C8
Selecting the limit (threshold) value for suppression
of minor unbalance readings in grams, or ounces.
The unit of measurement (g or oz) depends on the
setting (- 5.4.3).
Ounces:
Range 0.12 to 0.71 oz
Factory-adjusted to 0.18* oz
Select another limit, e. g.: 0.50 oz
• Select Code C8
• Set the value 0.50
• Press ENTER
Note: The selection is permanently acquired.
Grams:
Range 3.50 to 20.0 g
Factory-adjusted to 5.0* g
Select another limit, e. g.: 5.50 g
• Select Code C8
• Set the value 5.50
• Press ENTER
Code C11
Main shaft stop position.
The positioning brake stops the main shaft close to
the correction position by initiating pulsing braking.
The positioning brake is activated after switch on and
after a measuring run has been carried out and found
an unbalance greater than the limit value.
• Select Code C11
• Select one of the following options:
0 = No positioning brake after measuring run.
1*= Positioning brake after measuring run for left plane.
2 = Position brake after measuring run for right plane.
Note: The selection is permanently acquired.
Code C12
Measuring spin counter.
Example: 222,123 measuring runs completed:
•
Select Code C12
•
Select one of the following options:
1
= Total number of measuring runs completed
2
= Total number of measuring runs where balancing
was successfully completed, indicated by OK
3
= Total number of optimizations or minimizations
4
= Total number of measuring runs in Service mode
5
= Total number measuring runs since last calibration
Every measuring run completed is saved. Maximum
count is 999,999 measuring runs. Once this number
is reached, the counter is reset to zero. The informa-
tion is primarily useful for statistical purposes, for
example, to monitor the endurance of faulty parts, or
monthly (yearly) use of the machine, etc. The mea-
suring runs performed while the machine is switched
on are transferred to the permanent memory and
added when it is switched off.
Note: The total counter (option 1) cannot be deleted.
Code C14
Readjustment of the machine by the operator
•
See instruction on chapter 7.0 of this manual.
Code C21
This code provides information about the program
version and the balancer model name
-
Go into code C21.
Information about the software version appears.
-
Press the "-" key to view the Kernel version.
The information is visible for as long as the key is
pressed.
-
Press the "+" key or the "FINE" key to view the
balancer model.
Note: The information is visible for as long as the key
is pressed.
EEWB333B
35