Table des Matières
Publicité
16
4
67
16
350
65
67
600
25
26
28
27
21
24
58
23
20
22
69
68
15
3
4
2
1
65
320
30
27
*
64
72
75
310
66
360
62
71
70
63
45
59
42
1
34
31
2. INSTRUCTIONS FOR USE
2.1) Preparation
24
(Ref. to Figs. 1, 2)
4
With the tool in the rest position, proceed as follows:
– Select the appropriate die set for the connector.
26
– Open the latch (25) and release the upper die holder (24).
– Insert one die into the upper die holder (24) and one die into the lower die support
31
(27).
– Close the latch (25).
18
– Insert the conductor in
the connector.
19
– Position the connector
8
11
between the dies and
ensure the correct loca-
tion of the crimp.
Ensure that the latch
17
and the upper die hol-
der are fully secured,
otherwise damage may
6
9
occur during tool
operation.
77
2.2) Die advancement
– Grip the tool firmly and comfortably and press the operating button (3) to activate the
57
motor-pump and advance the lower die. To halt the advancement, release the operating
button (3) and the motor will cut out.
21
Make sure the dies are exactly positioned on the desired crimp point otherwise
re-open dies following instructions as per § 2.5 and reposition the connector.
500
2.3) Compression
– By keeping operating button (3) pressed, the motor continues to operate: the ram will
400
gradually move forward until the two dies touch.
– It is recommended to keep operating until the maximum pressure valve is activated and
57
a "click" is heard, after which the dies will automatically re-open until the ram is fully
17
retracted. It is always possible to interrupt automatic retraction of the ram by a short
push on the operating button (3).
18
4
19
100
18
10
1
24
9
210
7
8
58
16
20
11
220
17
TIGHTENING TORQUE
15
COUPLE DE SERRAGE
DREHMOMENT
PAR DE TORSION
COPPIA DI SERRAGGIO
8 Nm (5.9 lbf ft)
*
300
ENGLISH
25
250
59
27
FIG. 2
15
Publicité
Table des Matières
