Water Connection - Bosch AQT 42-13 Notice Originale

If the supply cord is damaged, it
u
must be replaced by the manufac-
turer, its service agent or similarly
qualified persons in order to avoid a
hazard.
If the plug is damaged, pay attention
u
to the following:
Plugs and sockets situated near the
u
work site or outdoors should be to
class IP 55 of BS 5490 to provide
adequate protection against ingress
of water, etc. and cable entries re-
quire effective sealing. Rubber
shrouds should be provided over
cable glands. Drip-proof (class IP X2
of BS 5490) plugs and sockets to BS
4343 are suitable for use indoors
where the plug is away from the wa-
ter spray area where the appliance is
in use.
Never touch the mains plug with wet
u
hands.
Do not pull plug while operating the
u
device.
Do not run over, crush or pull the
u
power supply cord or extension
cord, otherwise it may be damaged.
Protect the cable from heat, oil and
sharp edges.
Do not use the unit, if the power sup-
u
ply cord or important parts, e. g.
high-pressure hose, power gun or
safety devices are damaged.
Warning: Inadequate extension
u
cables can be dangerous.
If an extension cord is used, the plug
u
and socket must be of watertight
Bosch Power Tools
construction. The extension cord
must have a cross section in accord-
ance with the operating instructions
and be protected against splashed
water. The connection must not be in
water.
When replacing plugs on the power
u
supply cable or extension lead the
spray water guard and mechanical
stability must remain intact.

Water connection

Comply with the regulations of your
u
water supply company.
All connecting hoses must have
u
properly sealed joints.
Make sure that the supply hose is at
u
least 12.7 mm (1/2") in diameter
and is reinforced.
The appliance should never be used
u
on the drinking water supply without
a back flow valve. Water which has
passed the back flow valve is re-
garded as undrinkable.
The high-pressure hose must not be
u
damaged (danger of bursting). A
damaged high-pressure hose must
be replaced immediately. Only use
hoses and connections recommen-
ded by the manufacturer.
High-pressure hoses, fittings and
u
couplings are important for the
safety of the appliance. Use only
hoses, fittings and couplings recom-
mended by the manufacturer.
Only clean or filtered water should
u
be used for intake.
English | 13
F 016 L81 843 | (15.02.2019)