Operating The Appliance; Button(S) Description - VINCENT CD-S7 DAC Manuel D'utilisation

Many devices which can be controlled by a switching signal (not preamplifiers or integrated ampli-
fiers), have two terminals which do not differentiate between input and output. In this case either of
the two can be selected.
"POWER CONTROL" sockets of preamplifiers or integrated amplifiers must not be interconnected!
All receiving devices must not be connected to more than one preamplifier or integrated amplifier
(directly or indirectly)!
Operation
Switch on and off
Change the level of the
analogue audio outputs
(14) at the rear panel
Change the brightness of
the front panel display

OPERATING THE APPLIANCE

BASIC FUNCTIONS AND SETTINGS
Button(s) Description
The amplifier is switched on and off using this button at the front panel,
there is no standby option. When switched off the device is internally sepa-
rated from the AC power. As a precaution, before switching on, the volume
POWER (4) setting of your system's amplifier and the headphone volume (13) should be
reduced. Once it is switched on, the "WARM UP" LED (6) lights up and the
device needs a few seconds until it is ready for operation. It is ready when
the warm-up LED has gone out.
This function may only be activated with the remote control and only during
playback. This control is to allow the adaptation of the player to the system
(mainly the amplifier) and it must not be used to change the volume of the CD
player in daily use. It is sufficient for almost all amplifiers/receivers/preampli-
fiers to put the setting to the maximum and to leave it there. A different value is
VOL + (36)
only used if the CD player is much louder compared with the other sources at
VOL – (37)
the amplifier/receiver or it is distorted (clipping). Hold down the "VOL+" button
to raise the output level. Use the "VOL-" to reduce it. The two-figure value of the
volume appears in the display. The maximum signal level is reached with a set-
ting of 26 and the minimum is at 00. This volume control has no effect on the
volume of the headphones (12) connected to the CD player. The HDCD signal
is only decoded if the volume is set to its maximum "26".
This function can only be operated using the associated remote control button.
DIMMER
When repeatedly pressed, the display (3) brightness is periodically reduced
(21)
(1x), switched off (2x) and restored to the original, maximum brightness (3x).
Vincent
39