Operating The Appliance; Button(S) Description - VINCENT CD-S2 Manuel D'utilisation

Operation Button(s)
Switch on and off POWER (3)
Change the level of the
VOL+ (33)
analogue audio outputs
VOL- (34)
(13) at the rear panel
Volume of the connec-
LEVEL (12)
ted headphones (11)
Change the brightness
of the front panel DIMMER (17)
display

OPERATING THE APPLIANCE

BASIC FUNCTIONS AND SETTINGS
Description
The amplifier is switched on and off using this button at the front panel, there is
no standby option. When switched off the device is internally separated from
the AC power. As a precaution, before switching on, the volume setting of your
system's amplifier and the headphone volume (12) should be reduced.
This function may only be activated with the remote control and only during
playback. This control is to allow the adaptation of the player to the system
(mainly the amplifier) and it must not be used to change the volume of the CD
player in daily use. It is sufficient for almost all amplifiers/receivers/preamplifiers
to put the setting to the maximum and to leave it there. A different value is only
used if the CD player is much louder compared with the other sources at the
amplifier/receiver or it is distorted (clipping). Hold down the "VOL+" button to
raise the output level. Use the "VOL-" to reduce it. The two-figure value of the
volume appears in the display. The maximum signal level is reached with a set-
ting of 26 and the minimum is at 00. This volume control has no effect on the
volume of the headphones (11) connected to the CD player. It changes the out-
put level of all analogue outputs to the same extent.
This function can only be operated on the front of the device. Turn the dial
"LEVEL" clockwise to increase the volume in the headphones and anticlockwise
to reduce the volume. This volume control has no effect on the output level of the
analogue "AUDIO OUTPUTS" (13) on the back of the device.
This function can only be operated using the associated remote control button.
When repeatedly pressed, the display (2) brightness is periodically reduced
(1x), switched off (2x) and restored to the original, maximum brightness (3x).
Vincent
35