VINCENT CD-S7 DAC Manuel D'utilisation page 42

Operation
Delete the selected
playing sequence
Switch between normal
and random playback
Switch between playing
the content of the CD
once, repeating an indivi-
dual track and repeating
all the tracks on the CD
Repeat a custom
section of the track
as an endless loop
Play a short introduction
of every track
Vincent
42
OPERATING THE APPLIANCE
ADVANCED PLAYBACK FUNCTIONS
Button(s) Description
This button deletes a program set up with the "PGM" function (32). If no pro-
gram has been set up, then this button has no function. If the button is pressed
CANCEL during a pause, any selected program will be deleted and you can continue
(31) to play the current track and the remaining CD tracks with "PLAY/PAUSE"
(7)(26). Just as with the program set-up, this action may only be performed
with the remote control.
The function activated with this remote control button ensures that all the CD
tracks are played in random order. This function cannot be used for playing a
program set up with "PGM" (32). If this button is pressed during play or
RANDOM
pause, the current track is stopped and the playing of all the CD tracks in ran-
(33)
dom order begins. In the display, this play mode will be indicated by the text
"RAN". Pressing the "RANDOM" button again switches off random playing
and playing will continue from the current position.
If this button is pressed once while the CD is playing, the current track will
be played over and over again when it has finished. In the display (3) this
operation mode is indicated by the text "REPEAT 1". If this button is pres-
sed twice while the CD was playing, then the entire CD or the entire pro-
gram will be played over and over again when it has finished. In the dis-
REPEAT (25)
play this operation mode is indicated by the text "REPEAT ALL". A third
press of the key switches this function off. The desired repeat mode can
also be switched on even when play is stopped or for a selected pro-
gram. The "REPEAT" button is to be found only on the remote control.
While the CD is playing, the first press of this key marks the start of the
section (A) and the second press marks the end of this section (B). As soon
as both points are selected, the player continues to play the marked
extract over and over again until the "A-B" key is pressed again or
A-B (23)
"STOP" (6)(28) is pressed. In the display (3) this play mode is indicated
with the symbol "A
the "STOP" key (6)(28), the marked points will be deleted. This play opti-
on too can only be controlled via the remote control.
You can press this remote control key if the beginning of every track is only to
be played for a brief time. In this mode the first ten seconds of the track will
be played then it will skip to the next track in the sequence. This function is
also known by the term "Intro Scan". Even if a program has been set up for
the play sequence (32), all the CD tracks will each be played once for a
INTRO (24)
brief time after the "INTRO" key has been pressed. Pressing this key again
ends the Intro Mode and continues playing the remaining section from the
current position onwards. The text "INTRO" will be shown on the display (3)
while the "Intro Scan" is active. If this key is pressed during play or pause, the
Intro Mode always starts with the first CD track.
÷
B". After the A-B playback has been stopped with