Installation; Cable Connections - VINCENT CD-S7 DAC Manuel D'utilisation

Set up the cable links in a sequence as follows. Connect the power cable between device
and power supply only after all other connections have been made.
Protective caps
Prior to the first installation the pro-
tective plastic caps must be removed
from all the connections used at the
rear of the unit.
RCA connections
Mechanically identical RCA
plugs are available for analogue and digital out-
puts. Make sure that you do not get these connec-
tions confused during installation!
Make sure that you do not mix up the analogue con-
nectors for right and left. The RCA plugs for these are
mostly colour coded as follows: red for the right chan-
nel, black or white for the left channel.
Cables To make the most of the components' sound potential, only high quality loudspeakers and
connecting cab les, for example Vincent cables, should be used. Your local stockist will be
glad to advise you about this.
A set of headphones equipped with a 6.3 mm jack can be plugged into the "PHONES" socket (12) on the front
of the appliance.
All headphones with an impedance of between 32 Ohm and 600 Ohm may be used. Unsuitable headphones
with too low impedance may damage the amplifier or produce such unexpectedly loud volume that your hearing
may be damaged. The volume should be reduced (13) for safety reasons before a set of phones is connected.
Vincent
34

INSTALLATION

DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
1 2
O UT PU T OU
CONNECTING HEADPHONES

Cable connections

Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
To make the most of the components' sound poten-
tial, only high quality loudspeakers and connecting
cables, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
- wrong - - correct -