EUROM Golden 2000 Giant Manuel D'utilisation page 27

B. Directly attaching to the wall:
Attach the suspension bracket (A) horizontally to the wall using the four
-
cotter bolts (C).

Adjust the device to the required radiation angle. Fasten all screws another time
firmly and scheck or the heater is firmly mounted. Now your infra red heater is
ready for use.

For personal protection the installation, to which the Eurom Golden Giant is
connected, has to be equipped with an earth fall device (max. 30 mAmp).
Under some circumstances it may be attractive to make a fast connection between
the heater and the main supply, and to operate the heater with a switch. Because
the Eurom Golden Giant has a high water tightness (IP65) and for safety reasons,
such a connection has to be made by a qualified electrician
Working
Check for every use:
- or the appliance doesn't show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating
duet o wind or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V-50Hz) and is
grounded.
If everything is all right you can insert the plug into the socket.
The Golden Giant has a remote control that works with 2 AAA batteries (not
oncluded). While using, point the remote control to the receiving point of the heater.
If there are obstacles between remote control and the heater, it will not work!
Remove the batteries out of the season, that will extend the life of the remote control.
When you use the appliance for the first time (or after a long time again), observe it
during the first 10 till 15 minutes to be sure that is works trouble-free.

Press the main switch on the rear side of the
device to "I" (on).

Set the device into operation by pressing the ON
button of the remote control.

With the Ʌ-arrow, you can switch to a higher
heating level

With the V-arrow, you can switch to a lower
heating level

Pressing on the MAX button takes you straight to
the highest heating level.

To stop the unit, first press the 'off' button on the
remote control. Then turn it off by pressing the
on/off-switch to 'O' (off). Finally, unplug it from
the wall outlet. Allow the heater to cool down.
27