Information On Water Resistance - Crosscall CORE-X4 Guide D'utilisation

• Do not put your phone or accessories in containers with a strong magnetic field.
• Do not leave magnetic data storage devices near your phone. The radiation emitted by
the phone may erase the information stored there.
• Keep the phone away from direct sunlight. Do not expose your phone to high
temperatures, and do not use it in the presence of flammable gases (e.g. petrol station).
• Hold your phone at least 15mm from your body when you make calls.
• Small parts may cause choking.
• Your phone can emit a loud sound.
• Avoid impacts or damage to your phone.
• Some parts of your phone are made of glass. The glass is likely to break if your phone
falls on a hard surface or suffers an impact. If the glass breaks, do not touch the glass
parts of the phone and do not attempt to remove the broken glass from the phone. Do
not use your phone until the glass has been replaced by an authorised operator.
• Do not attempt to take apart your phone or its accessories. Phones should only be
serviced or repaired by qualified personnel.
• The power outlet should be located near the phone and must be easy to access.
• Comply with all laws and regulations relating to the use of the telephone. Respect the
privacy and rights of others when using your phone.
• Follow the instructions in this manual for using the USB cable. Otherwise, your phone or
PC may become damaged.
• Clean your phone with a soft, dry cloth. Please do not use water, unless respecting
the conditions mentioned below «Information on water resistance», alcohol, soap or
chemicals.
• Be sure to back up your important data. A repair or other factors may lead to data loss.
• Do not disconnect the phone when transferring files or formatting the memory. This
could cause program failure or file damage.
• Keep the phone and charger out of the reach of children. Do not let children use the
phone or charger unattended.
• Keep small phone accessories out of reach of children in order to avoid choking.
• Do not let your children or pets chew or lick the device.
• Do not modify or recondition your phone.
• Do not expose your phone to flames, explosions, or other sources of danger.
60
• Please switch off your phone when you are near explosive materials or liquids.
• The phone must only be connected to a USB 2.0 interface.
• The ideal operating temperature is between 0°C and 40°C. The ideal temperature for
storage is between 20°C and 50°C.
• Stop using your device if any of its parts are cracked, broken, or if it overheats.
• Do not press your device against your eyes, ears or any other part of your body, and do
not put it in your mouth.
• Do not use the flash near the eyes of people or animals.
• Only use the original accessories for this phone and do not install its battery in another
phone.

INFORMATION ON WATER RESISTANCE

• You have just bought an IP68 compliant mobile phone. In order to guarantee optimal
use and water resistance, ensure that all the flaps and plugs on the openings and the
cover are correctly sealed.
• Do not open the caps and SIM drawer of the device if it is in the water or in a very humid
environment.
• Make sure that the caps are not damaged when you open or close them. Make sure that
the seal is free from any debris, such as sand or dust, to avoid damaging the device.
• The flaps covering the openings may come loose in the event of a fall or impact.
• Make sure that all the covers are properly aligned and completely closed.
• If the device has been submerged in water or the microphone or loud speaker is wet,
the sound may not be clear during a call. It is recommended to wait a few minutes
after the immersion of your device to recover its initial audio quality. Make sure that the
microphone or loud speaker is clean and dry by wiping it with a dry cloth.
• If the device gets wet with salted or chlorine water, rince it with tape water, and then dry
it thoroughly with a soft, clean cloth. Dry carefully caps and connectors.
• The device's water resistance may cause slight vibrations in certain conditions. These
vibrations, for example when the volume is turned up high, are entirely normal and do
not affect the performance of the device.
• Do not disassemble the waterproof membrane over the microphone or the speakers
and do not use a device that can damage it (sharp, cutting, etc.).
• Do not expose the product to metal particles : they may accumulate on the speaker of your
product because of the magnet use inside of the speaker component. The metal particles
can be cleaned with a soft cloth. You could instead put it un a transparent plastic bag.
61