EWT AERO 360+ Manuel D'utilisation page 16

Oscillation On/Off (E)
This button is used to switch on or off the appliance's
horizontal oscillation function. You can set the angle of
oscillation to 30°, 90°, 160° or 360° as displayed by the LED
indicator light by pressing the
Manual 90° tilt
The vertical tilt of the appliance can be altered manually up to
an angle of 90°. Make sure than the appliance is switched off
before altering the tilt position.
NB – When the product is left running without switch/control
operation for 1 minute the LED indicator light display will
switch off automatically, this is to avoid user disturbance
or distraction by the light (particularly if used at night), The
lights will switch on again when the user activates any
control button (except the off button), the product can then
be operated normally as described above, if the 'off' button
is activated the product will just switch off and the lights will
not re-energise.
REMOTE CONTROL
A. Appliance On/Off
B. Speed control
C. Fan mode control
D. Timer
E. Oscillation On/Off
1. When inserting or removing the battery, please consult
the diagram below. Pay attention to the guide on the lid
explaining the positioning of the positive and negative
symbols on the battery.
2. Remove the protective cover from the battery slot of your
remote control and place the 3V CR2032 inside.
3. Avoid dropping the remote control or allowing it to fall to
the floor.
4. Make sure that the remote control is facing one of the
16
aero360plus_A5.indd 16
button.
two sensors located on the front and on the back of the
appliance when you use it.
5. The remote control will work at a distance of up to 6
metres.
6. Batteries contain materials that are dangerous for the
environment. When disposing of the appliance, the
batteries must be removed from the remote control and
disposed of in an appropriate place - Please refer to
recycling section.
CLEANING AND MAINTENANCE
• Always unplug the appliance before cleaning it.
• Clean the surface of the appliance using a soft cloth, do
not use any water.
• If the appliance is very dirty, clean the surface using
a damp cloth (add a non-corrosive cleaning product if
required.
• Do not use corrosive detergents, corrosive solvents or
chemical products.
• Do not use an abrasive sponge, scouring pad or hard brush
to clean the appliance.
• Do not immerse the main body of the appliance into water.
• Ensure that the motor and the other electrical components
do not come into contact with water.
• If the appliance is not to be used for a long period, pack it
away carefully. Store it in a dry and ventilated area where
it will not be affected by dust.
• Clean the outer grill using a non-corrosive detergent and
a soft brush.
THIS APPLIANCE IS SOLELY DESIGNED FOR DOMESTIC USE
WARRANTY
This EWT appliance comes with a two- (2) year warranty
®
which begins on the date of purchase and only applies to
use under normal conditions. The warranty does not apply to
damage incurred as a direct or indirect result of inappropriate
use, negligence, improper use, accidents, improper repairs
or lack of maintenance. Please keep your receipt/invoice as
proof of purchase.
The accessories which come with this are consumables and
the warranty pertaining to them is limited to one (1) month.
FR EN NL
14/11/19 11:04