IKRA Mogatec IPCS 2525 Manuel D'utilisation page 35

3. Guide bar
Remove sawdust in the bar groove and the oiling port.
(Type: Sprocket nose)
Grease the nose sprocket from the feeding port on the
tip of the bar.
4. Others
Check for fuel leakage and loose fastenings and dam-
age to major parts, especially handle joints and guide
bar mounting. If any defects are found, make sure to
have them repaired before operating again.
WARNING
This saw is equipped with one of the following low
kickback bar/chain combinations:
Part Number
Bar Size Guide Bar
10inch (25cm) 100SDEA041
For replacement, use only above bar and chain
Periodical check points
1. Cylinder fins
1. Remove the starter case.
2. Remove sawdust between the cylinder fins.
GB | Operating Instructions
2. Fuel filter
1. Using a wire hook, take out the fuel filter from the
(1) Groove
(2) Oiling port
2. Wash the filter with gasoline. Replace with new one
When returning the filter, use a pinch not to be folded
the suction pipe.
3. Oil tank
(1) Grease port
1. With a wire hook, take out the oil filter from the feed-
(2) Sprocket
Saw Chain
2. Wash the filter with gasoline.
Oregon 91P
When returning the filter, use a pinch not to be folded
the suction pipe.
4. Spark plug
Clean the electrodes with a wire brush and reset the gap
to 0.6 mm as necessary.
After spark plug maintenance, reinstall the plug and plug
cap firmly. (TORQUE: 14.7~17.6 Nm/150~180 kg-cm) Or
it may cause the fire accident.
(1) Cylinder fin
14
feeding port.
if clogged with dirt completely.
WARNING
ing port.
WARNING
WARNING
Spark plug type:
L8RTF / BOSCH