Maintenance And Repair - Dolmar PS-7310 Manuel D'emploi Et De Sécurité

WARNING!
5. Logs under strain require special attention to pre-
vent the saw from pinching. The first cut is made
on the compression side to relieve the stress on
the log (see fig. 33, 34). The bucking cut is then
made as shown. If the saw pinches, stop the
engine and remove it from the log.
WARNING!
6. Only properly trained professionals should work
in an area where the logs, limbs and roots are
tangled (i. e. a blowdown area, fig. 35). Working
in blowdown areas is extremely hazardous.
WARNING!
7. Drag the logs into a clear area before cutting.
Pull out exposed and cleared logs first.

Maintenance and Repair

Never operate a chain saw that is damaged, improperly
adjusted or not completely or securely assembled.
Follow the maintenance and repair instructions in the
appropriate section of this manual.
Always stop the engine and make sure that the chain
is stopped before commencing any maintenance or
33
repair work or cleaning the saw. Allow the chain saw
to cool off before doing any maintenance work (burn
hazard)!
When the chain saw is hot, do not cover it (with a
tarp, blanket, newspaper or the like).
Let the chain saw cool down before putting it in a
storage case or vehicle.
Chain saws with catalytic converter take longer to
cool down!
Do not attempt any maintenance or repair work not
described in this manual. Have such work performed
34
by your DOLMAR service shop only.
Maintaining and storing the saw
Keep the chain, bar and sprocket clean and lubricated;
replace worn sprockets or chains.
Keep the chain sharp. You can spot a dull chain when
easy-to-cut wood becomes hard to cut and burn marks
appear on the wood.
Keep the chain at proper tension. Tighten all nuts, bolts
and screws except the carburetor adjustment screws
after each use.
Keep spark plug and wire connection tight and clean.
Store saws in a high or locked place, away from chil-
dren.
35
The chain protection cover should always be put on.
WARNING !
17