Hurricane HBH 24 Mode D'emploi page 14

Anleitung HBH 24 SPK7 10.11.2005
GB
For easier operation and longer blade life, lubricate the
blade before and after each use. Apply light machine oil
along the edge of the blade bar.
• AIR FILTER
To Clean Air Filter:
1. Press down on tab (A) holding air filter cover in place,
remove cover (B) and lift filter (C) from air box (Fig. 6).
2. Wash filter in soap and water. DO NOT USE
GASOLINE!
3. Air dry filter.
4. Reinstall filter.
CAUTION: NEVER operate unit without the air filter or dust
and dirt will be sucked into the engine and damage it. The
air filter must be kept clean. If it becomes damaged, install a
new filter.
C
A
B
Fig. 6
• CARBURETOR ADJUSTMENT
The carburetor was pre-set at the factory for optimum
performance. If further adjustments are necessary, please
take your unit to the nearest professional.
• SPARK PLUG
1. Spark plug gap = 0,6 mm (0,025 In.) (Fig. 7).
2. Torque to 105 to 130 inch pounds (12 to 15 N•m).
Connect spark plug boot.
• STORING A UNIT
WARNING: Failure to follow these steps may cause varnish
to form in the carburetor and difficult starting or permanent
damage following storage.
1. Perform all the general maintenance recommended in
the Maintenance Section of your User Manual.
14
9:24 Uhr Seite 14
2. Clean outside surface of unit.
3. Drain fuel from the fuel tank.
4. After fuel is drained, start engine.
5. Run engine at idle until unit stops. This will purge the
carburetor of fuel.
6. Allow engine to cool (approx. 5 minutes).
7. Using a spark plug wrench, remove the spark plug.
8. Pour 1 teaspoon of clean 2-cycle oil into the combustion
chamber. Pull starter rope slowly several times to coat
internal components. Replace spark plug.
9. Store unit in a cool, dry place away from any source of
ignition such as an oil burner, water heater, etc.
• REMOVING A UNIT FROM STORAGE
1. Remove spark plug.
2. Pull starter rope briskly to clear excess oil from
combustion chamber.
3. Clean and gap spark plug or install a new spark plug
with proper gap.
4. Prepare unit for operation.
5. Fill fuel tank with proper fuel / oil mixture. See Fuel and
Lubrication Section.
Ordering replacement parts
Please quote the following data when ordering replacement
parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to www.isc-
gmbh.info