Getting Started - XciteRC twenty4 Série Mode D'emploi

Getting started

Before you start, check all functions of the remote control. Does the vehicle follow exactly and directly your
commands? Or does it react delayed or choppy? If yes, do not start anyway, but check transmitter and drive
EN
batteries and recharge or replace if necessary.
The run time of your twenty4 depends on the surface. The maximum run time is reached on a straight and
levelled surface. In hilly terrain or grass, the run time is much shorter, also the motor, speed controller and bat-
tery gets much warmer. If the battery is weak, the vehicle first gets slower until it finally stops completely. To
increase the life time of the drive battery, you should cease operation when the vehicle begins to slow down.
1. Switch on the transmitter, ON/OFF-switch in position I.
2. Switch the vehicle ON.
to connect the transmitter with the reciever properly.
3. Drive:
A
4. Steering trim: Drive slowly forward on level ground. Now check the straight ahead driving and adjust with
20
Note: wait about 5 sec. before you move the throttle trigger. This is needed
1x C
2x D
B
A
C
Getting started
B
D
twenty4 series