The Remote Control System; Transmitter - XciteRC twenty4 Série Mode D'emploi

The remote control system

Here you get an overview of the remote control system of your twenty4 and
its various features and settings. Before the first flight, you should have read
EN
and understood all these functions and settings.
• Make sure that the transmitter is turned off - ON / OFF switch in position
O.
• Now open the battery compartment cover on the bottom of the transmit-
ter and insert two AA batteries (or rechargeable batteries) into the battery
compartment of the transmitter. Pay attention to the correct polarity!
• Close the battery compartment cover and turn on transmitter – push ON
/ OFF switch in position I.
• The red LED must light up.
model may not be started – crash hazard! Change transmitter batteries
immediately (or charge batteries).
• Pay attention to the LED also during operation. If the red LED flashes, stop
driving as soon as possible and replace transmitter batteries (or recharge
the batteries).

Transmitter

A: Steering wheel: direction right or left
B: Throttle trigger: controls the speed and direction of the model
C: Battery compartment
1. Control trim: adjusts the straight ahead driving
2. Servoreverse steering
3. On / Off Switch: Turns the power of the transmitter ON / OFF
4. Throttle trim: adjust the neutral position of the controller (always in the middle position!)
5. POWER/BIND-LED: indicates a "bound" receiver
NOTE: the adjuster for the throttle trim TH.TRIM and the servo reverse switch for steering ST.REV must
not be adjusted. So check the correct position before every ride: throttle trim to the center position (mark on
the adjuster points up), steering reverse: switch in position R.
18
NOTE: If the red LED is flashing, the
A
B
1
2
3
C
The remote control system
4
5
twenty4 series