Getting Started; Rc Functions - XciteRC X-Dive micro Série Mode D'emploi

Getting started · RC functions

Getting started

Switching on:
WARNING: Close the waterproof switch cap of the submarine completely before putting under water - risk of sinking!
Waterproof
Switch Cap
close
Outlet
• Close the waterproof switching cover completely.
• The lighting goes on, the boat is now ready for operation.
• Hold the back of the submarine and put the front into the water, then shake it a few times according the
illustration. Then release it completely in the water.
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!

RC functions

Dive
• Press the dive button to dive with the submarine. Through the dip tank, the boat can processed on the
spot and reappear.
• With some skill the boat can be kept on a certain dive depht by alternately filling or emptying the ballast
tanks while driving.
• If the boat loses balance while driving and sinks uncontrollably, there is probably some water in the sub-
marine. To release it, open the under-side outlet. The water is removed by shaking the boat.
Outlet
• WARNING: close the under-side outlet carefully – risk of sinking!
• Does the submarine did not dive at all, tip it upside down into the water according the illustration and
gently move a few seconds. Then completely leave the water. It will turn itself after a short time and is
then ready for use.
X-Dive micro U-Boot
Green light
Close
completely
Yellow light
EN
17