Cavist 46 Manuel D'utilisation page 9

During first use
Important: When you use the wine cooler for the first time or restart the appliance after it has been turned off for
a long time, there could be a few degrees variance between the temperature you select and the one indicated
on the display. This is normal and it is due to the length of activation time. Once the wine cabinet has been
running for a few hours everything will be back to normal.
When you first switch on the appliance, the compressor will run continuously until the wine cabinet reaches a
cool enough temperature.
During this period of time, you should try not to open the door frequently or place bottles inside of the appliance
If the unit is switched off or unplugged, you must allow at least 5 minutes before restarting the appliance or
reconnecting it to your mains supply.
Switching on the appliance and setting the temperature
Important note:
The temperature setting of the lower zone must always be the same or higher than that in the upper zone.
•
For optimal performance the temperature setting of the 2 zones should differ by at least 4°C
•
Follow the below steps to switch on the appliance and set the required temperature:
1. Switch the appliance on at the plug, the appliance will beep and the internal temperature of each zone will
be shown on the 2 displays.
2. The temperature setting for each zone is adjustable within the range of 5°C to 22°C or 40°F / 72°F.
3. When you press the temperature up or temperature down controls for the first time, the LED displays will
show the factory default temperature setting of 10°C / 50°F for the upper zone and 16°C / 60°F for the lower
zone.
4. Use the zone selection button to choose the zone you want to set the temperature of; the display of the
zone you wish to set the temperature of should be flashing. Then use the temperature up and temperature
down controls to set the desired internal temperature.
5. The temperature will increase by 1°C or 1°F if you touch the temperature up control once and will decrease
by the same amount if you press the temperature down control once.
6. When you set a new temperature, the display will show the new selected temperature for 3 seconds, before
showing the previous/actual temperature. The cooler temperature will gradually reduce or increase to the
newly set temperature and the display will adjust accordingly.
7. To view the set temperature in the wine cooler, press the temperature up or temperature down control. The
display will flash the temperature for 5 seconds.
Note: We recommend that the door is not opened for a minimum of 4 hours to allow the appliance to reach the
standard operating temperature.
Note: The temperature of the drinks and how often the door is opened affects the temperature in the cooler. If
required, change the temperature setting.
Note: Cool air falls and warmer air rises, so there will be a slight temperature variation between the top of the
cabinet and the bottom of the cabinet.
Important: When the temperature is changed, the compressor works harder to reach the required temperature.
During this time, the side panels of the wine cabinet can reach up to 45°C however they will cool down when the
set temperature is reached.