Humidity Control; Removing The Shelves - Cavist 46 Manuel D'utilisation

You can also decant your wine; decanting will "open up" the flavour of both young and old wines, but younger
wines in particular. To decant, pour the wine slowly and evenly into your decanter.

Humidity control

Important note: this feature is optional and will only enhance the storage conditions of the wine within the
appliance. If you do not want to use this feature simply remove the humidity reservoir(s).
The wine cooler is equipped with a system for maintaining the correct level of humidity for storing wine. There is
a humidity reservoir (a small plastic container) installed on the top shelf of the top zone. Remove this from the
runner on the top shelf/shelves and fill it/them ¾ full with cold water and reinstall onto the runners.
Note: You must ensure the humidity reservoir is positioned correctly on the runners on the top shelf to avoid the
possibility of water spillage.
Note: Check the water level regularly and refill as necessary.

Removing the shelves

For easy access to the bottle stored, pull the shelves out approximately 1/3. The shelves are designed with an
emergency stop to prevent them being removed too far when loaded.
To prevent damaging the door seal, make sure the door is fully open when removing shelves. To remove any of
the shelves, move the shelf to the position where the notch/indentation on each side of the wooden shelf is
exactly under the plastic posts. Then simply lift the wooden shelf upwards and remove.
When replacing the shelf you must ensure that you align the notches/indentations on the wooden shelves with
the plastic posts and that wooden shelf is dropped under the plastic posts.