Multiplex Alpina Carbotec Notice De Montage page 15

Assembly instructions
edge. Measured close to the fuselage. With the Centre of Gravity gauge
MPX order no. 693054 it is very easy to set the CG correctly. An angle of
incident of 1,0° can be set with the Incidence gauge MPX order no.
693053. Keep this settings for the first flights, probably you will never
change it. After setting both, you can measure and set the rudder throws.
The table below shows our recommendations. These are based on the
experience of multiple modellers and you probably don't need to change
them.
Rudder throws
The rudder throws are set in mm and are always measured where the
control surface has its biggest depth. For the elevator we added the value
in degrees as well. So the elevator throw can also be set using the Inci-
dence gauge.
After finishing the control throws, the servo covers can be installed using
clear tape or UHU Por glue (picture 44/45).
Throw
--------------------------------------------------------------------
Ailerons servos
Aileron
Flap (Thermal / Speed)
Spoiler (Butterfly)
---------------------------------------------------------------------
Flap servos
Aileron
Flap (Thermal / Speed)
Spoiler (Butterfly)
---------------------------------------------------------------------
Elevator servos
Elevator 6º or.
Mix to Flap (Thermal / Speed)
Mix to Spoiler (Butterfly)
---------------------------------------------------------------------
Rudder servo
Rudder left / right
---------------------------------------------------------------------
Tow hook servo (glider version)
Set complete opening and closing of the hook
---------------------------------------------------------------------
The control settings can still be adjusted individually.
Important note:
up(+) /throw down (-) in mm
+22 / -11, Offset ~40%
-3 / +2
+28 / 0
+10 / 0, Offset ~20%
-4 / +2
0 / -37
up (+) / down (-)
+12 / -12
-2 / -1
-5
50 / 50
Safety
Safety is the First Commandment when flying any model aircraft. Third
party insurance is a basic essential. If you join a model club suitable co-
ver will usually be available through the organisation. It is your personal
responsibility to ensure that your insurance is adequate (powered model
aircraft). Make it your job to keep your models and your radio control
system in perfect order at all times. Check the correct charging procedure
for the batteries you are using. Make use of all sensible safety systems
and precautions which are advised for your system. Gather as much in-
formation as you can from our main catalogue, or consult our website
www.multiplex-rc.de.
MULTIPLEX products are produced by knowledgeable model flyers: practi-
cal applications from practical experience. Always fly with a responsible
attitude. You may think that flying low over other people's heads is proof
of your piloting skill, but others know better: the real expert does not need
to prove himself in such ways. Let other pilots know that this is what you
think too. Always fly in such a way that you avoid endangering yourself or
others. Bear in mind that even the best RC system in the world is subject
to outside interference. No matter how many years of accident-free years
of accident-free flying you have under your belt, you have no idea what will
happen in the next minute.
Before every flight it is essential to check that the battery, wings
and tail surfaces are securely fixed. Check every working system!
We - the MULTIPLEX team - wish you many hours of pleasure in building
and flying your model. Happy landings!
EN
15