Reely Wild Hawk 2.0 Notice D'emploi page 44

• If you pull the control stick for the elevator and the fin unit upwards, the elevator unit must deflect downwards. In
flight, the landing gear is then pressed upwards and the model descends.
• This control function is required to put the model into a normal light position if it wants to ascend too much due to
a control error or a gust of wind.
• If you pull the control stick for the elevator and the fin unit to the left, the fin unit must deflect to the left. This pushes
the landing gear to the right in flight and the model will roll around the longitudinal axis to the left due to the changed
flow situation on the wings.
• You have to slightly pull on the elevator so that the model does not loose any height in this slanted position.
• If the rudder reacts opposite to the function described above, you may change the direction of the rudder servo with
the reverse switch (see figure 2, pos. 7). There is a separate switch for each control channel. The rudder direction
is switched with the outer left switch (CH1).
44
Figure 11
Figure 12