Programming The Remote Controls; Memorising 2 Or 4-Button Remote Controls; Memorising 3-Button Remote Controls; Programming On An Io Light Receiver - Simu SD100Hz Manuel D'installation

SIMUDRIVE SD100Hz
7

PROGRAMMING THE REMOTE CONTROLS

7.1

Memorising 2 or 4-button remote controls

NOTICE
If this procedure is carried out using a button which has already been memorised, the button will be
cleared.
1] Press the "PROG" button for 2 s.
ð The "PROG" indicator light is permanently lit.
NOTICE
Pressing "PROG" again allows the next function to be memorised (230 V aux output control)
2] Press the button selected to control the function (complete opening, Aux 230 V output control).
ð The "PROG" indicator light flashes for 5 s.
Complete opening control
Memorising remote controls [} p.32]
Aux 230 V output control
> Illustration 21
7.2

Memorising 3-button remote controls

> Illustration 22
NOTICE
If this procedure is carried out using a remote control which has already been memorised, the remote
control will be cleared.
1] Press the "PROG" button for 2 s.
ð The "PROG" indicator light is permanently lit.
NOTICE
Pressing "PROG" again allows the next function to be memorised (230 V aux output control)
2] Press "PROG" at the back of the remote control.
ð The "PROG" indicator light flashes for 5 s.
Function of the 3-button remote control buttons
Function
Complete opening
Aux. 230 V
8

PROGRAMMING ON AN IO LIGHT RECEIVER

This function enables automatic activation of remote lighting connected to the receiver during garage door
movements.
1] Switch the light receiver to programming mode (refer to the receiver manual).
2] Briefly press the "PROG" button.
ð The PROG indicator light flashes once.
ð The lighting connected to the light receiver comes on and then goes out.
Up button
Complete opening
Aux. output ON
My button
Stop
EN
Down button
Complete closing
Aux. output OFF
37