Advanced Parameter Setting; Using The Programming Interface - Simu SD100Hz Manuel D'installation

SIMUDRIVE SD100Hz
5.2.5 Key contact
> Illustration 18
5.2.6 Antenna
> Illustration 19
6

ADVANCED PARAMETER SETTING

6.1

Using the programming interface

> Illustration 20
1] Press the "SET" button for 0.5 s to enter parameter setting mode.
ð Indicator light P0 flashes once.
2] Press the "+" or "-" button to change the value of the parameter.
ð The indicator light flashes x times to indicate the value selected.
3] Press the "SET" button for 0.5 s to confirm this value and move on to the next parameter.
ð If parameter P3 is selected, pressing the "SET" button for 0.5 s will cause you to exit parameter
setting mode.
4] Press the "SET" button for 2 s to confirm a value and exit parameter setting mode.
ð The integrated lighting and parameter setting indicator lights go out.
EN
35