Product Specifications; Preliminary Checks; Installation Environment; Risk Prevention - Simu SD100Hz Manuel D'installation

EN
Simu cannot be held responsible for any damage resulting from non-compliance with
the instructions in this guide.
If you have any doubts when installing the motorisation or to obtain additional inform-
ation, please consult the website www.simu.com .
These instructions may be modified in the event of a change to the standards or the
motorisation.
1.2

Product specifications

This product is a receiver for vertically opening roller garage doors for residential
use. To comply with standard EN 60335-2-95, this product must be installed with a
Single-phase SIMU not in excess of 1100 W motor and a Simu safety edge solution.
The assembly is designated as a "motorisation".
The main purpose of these instructions is to satisfy the requirements of the afore-
mentioned standard and to ensure the safety of equipment and persons.
1.3

Preliminary checks

1.3.1

Installation environment

CAUTION
Do not spray water onto the motorisation.
Do not install the motorisation in an explosive environment.
Check that the temperature range marked on the motorisation is suited to
the installation location.
1.4

Risk prevention

WARNING
Ensure that any danger zones (crushing, cutting, trapping) between the
driven section and the surrounding fixed sections created by the opening
of the driven section are prevented, or indicated on the installation.
Permanently affix the crushing warning labels near any fixed control devices or so
that they are clearly visible.
24
SIMUDRIVE SD100Hz