Cleaning The Cooktop - Fulgor Milano Sofia 30 Guide D'utilisation Et D'entretien

Parts and materials
Exterior finish
(Porcelain enamel)
Control knobs
(Stainless Steel)
Exterior finish
(Stainless Steel)
Igniters
(Ceramic)
Suggested cleaners
Hot sudsy water: rinse and dry thoroughly.
Non abrasive cleansers:
Fantastic®, Formula 409®.
Mild abrasive cleansers: Bon Ami®, Ajax®,
Comet®.
Liquid cleaners: Kleen King®, Soft Scrub®
Hot sudsy water: rinse and dry immediately.
If necessary, remove knobs (lift straight up).
Nonabrasive cleaners: Hot water and
detergent. Fantastic®, Formula 409®. Rinse
and dry immediately.
Cleaner polish: Stainless Steel Magic® to
protect the finish from staining and pitting;
enhances appearance.
Hard water spots: Household white vinegar.
Mild Abrasive Cleaners: Kleen King®
stainless steel liquid cleaner, Cameo®
aluminum & stainless steel cleaner, Bon
Ami®.
Heat discoloration: Bar Keepers Friend®.
Carefully wipe with a cotton swab dampened
with water, ammonia or Formula 409®.
Gently scrape soil off with a toothpick.

18 - Cleaning the Cooktop

Suggestions/Reminders
Acidic and sugar-laden spills deteriorate the
Ammonia, porcelain enamel. Remove soil immediately.
Do not use wet sponge or towel on hot
porcelain.
Always apply minimal pressure with abrasive
cleaners.
Do not soak knobs.
Do not use abrasive scrubbers or cleansers.
Do not force knobs onto valve shaft.
Pull knobs straight away from control panel
to remove.
When replacing knobs, make sure knobs are
in the OFF position.
Do not remove seats under knobs.
Stainless steel resists most food stains and pit
marks provided the surface is kept clean and
protected.
Never allow food stains or salt to remain on
stainless steel for any length of time.
Rub lightly in the direction of polish lines.
Chlorine or chlorine compounds in some
cleaners are corrosive to stainless steel.
Check ingredients on label before using.
Always apply minimal pressure with abrasive
cleaners especially on graphics.
Avoid excess water on the igniter. A damp
igniter will prevent burner from lighting.
Remove any lint that may remain after
cleaning.
EN
27