Transportation And Storage; Technical Data - Zenoah GZ360 Manuel D'utilisation

Engine starts but does not stay running
Check
Fuel tank
Carburettor
Air filter
Fuel filter

Transportation and storage

• Always store the chainsaw and fuel so that there is
no risk of leakages or fumes coming into contact with
sparks or naked flames from electrical equipment,
electric motors, relays/switches, boilers and the like.
• Always store fuel in an approved container designed
for that purpose.
• For longer periods of storage or for transport of the
chainsaw, the fuel and chain oil tanks should be
emptied. Ask where you can dispose waste fuel and
chain oil at your local petrol station.
• The guide bar cover must always be fitted to the
cutting attachment when the product is being
transported or in storage, in order to prevent
accident contact with the sharp saw chain. Even a
non-moving saw chain can cause serious cuts to
yourself or persons you bump into with an exposed
saw chain.
• Remove the spark plug cap from the spark plug and
activate the chain brake before storage or transport.
• Secure the product during transport.

Technical data

Engine
Cylinder displacement, cm
Cylinder bore, mm
Stroke, mm
Idle speed, rpm
Power, kW/hp @ rpm
321 - 004 - 27.09.2017
Possible cause
Incorrect fuel type.
Engine will not idle properly.
Clogged air filter.
Clogged fuel filter.
Transportation and storage
Technical data
3
Possible action
Drain it and use correct fuel.
Contact your service agent.
Clean the air filter.
Replace the fuel filter.
To prepare your product for long-term
storage
1. Empty the fuel tank and chain oil tank in a well
ventilated area.
2. Store the fuel in approved cans in a safe place.
3. When using vegetable based saw chain oil,
dismantle and clean the saw chain and the groove in
the bar.
CAUTION: If you do not dismantle and
clean the saw chain and the groove in
the bar, there is a risk of the saw chain
oil oxidizing. This causes the saw chain
to get stiff and the bar tip sprocket to
become jammed.
4. Fit the guide bar cover.
5. Clean the product. See instructions under
Maintenance schedule on page 37 .
6. Make sure that a complete service is carried out.
GZ360
35,2
40
28
2900
1,5/2,0 @ 10 000
39