Zenoah GZ360 Manuel D'utilisation page 3

15. Spark plug cap
16. Muffler
17. Oil pump adjustment screw
18. Chain catcher
19. Throttle trigger lockout
20. Front handle
21. Saw chain
22. Bar tip sprocket
23. Guide bar
24. Spiked bumper
25. Chain tensioning screw
26. Product and serial number plate
27. Clutch cover
28. Throttle trigger
29. Guide bar cover
30. Combination spanner
31. Box spanner
32. Operator's manual
Symbols on the product
Careless or incorrect use of this product can
result in serious or fatal injury to the operator
or others.
Read the operator's manual carefully and
make sure you understand the instructions
before you use this product.
Always wear approved protective helmet,
approved hearing protection and protective
goggles or a visor.
This product is in accordance with
applicable EC Directives.
Noise emission to the environment
according to the EC Directive. The product's
emission is specified in the Technical data
chapter and on the label.
Both of the operator's hands must be used
to operate the chainsaw.
Never operate the chainsaw holding it with
one hand only.
321 - 004 - 27.09.2017
Never let the guide bar tip come in contact
with any object.
Warning! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
Chain brake, activated (right). Chain brake,
not activated (left).
Choke lever in "open position"
Choke lever in "closed position"
Air purge.
Refuelling.
Chain oil fill.
Adjustment of the oil pump.
yyyywwxxxxx
Note: Other symbols/decals on the product refer to
certification requirements for certain markets.
The rating plate showing
serial number. yyyy is the
production year, ww is the
production week.
3