Zenoah GZ360 Manuel D'utilisation page 14

formulated for air-cooled engines. Consult your
servicing dealer when you select an oil.
• Do not use two-stroke oil for water-cooled outboard
engines, also referred to as outboard oil.
• Do not use oil intended for four-stroke engines.
Gasoline, l
5
10
15
20
To mix gasoline and two-stroke oil
CAUTION: There is a risk that small errors
influence the ratio of the mixture drastically
when you mix small quantities of fuel.
Carefully measure the quantity of oil to be
mixed to make sure that you get the correct
mixture.
1. Fill half the quantity of the gasoline to be used.
2. Add the full quantity of oil and mix (shake) the fuel
mixture.
3. Add the remaining quantity of gasoline.
4. Carefully mix (shake) the fuel mixture and fill the fuel
tank of the product.
5. Empty and clean the fuel tank if you do not use the
product for some time.
Note: Do not mix fuel for more than 1 month at a time
and always mix gasoline and oil in a clean container
intended for fuel.
14
Chain oil
All Zenoah chainsaws have an automatic chain
lubrication system. On some models the oil flow is also
adjustable.
Chain oil must show good adherence to the saw chain
and also keep its flow characteristics during warm
Two-stroke oil,
summer and cold winter weather.
l
The chain oil from Zenoah has a vegetable oil base and
2% (1:50)
is also biodegradable. We recommend you to use of our
chain oil for maximum saw chain life and to minimise
0,10
environmental damage. If this chain oil is not available,
0,20
we recommend you to use a standard chain oil.
0,30 The fuel runs out before the chain oil from the two tanks.
This is a safety feature and it is necessary that you
0,40
follow the requirements below:
•
•
•
Consult your servicing dealer when you select a chain
oil.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
Use an oil of the right grade (suitable viscosity
range) to agree with the air temperature. If the oil is
too thin it will run out before the fuel. In temperatures
below 0°C (32°F) some oils become too viscous.
This can cause the oil pump to overload and result in
damage to the oil pump components.
Adjust the carburetor as recommended. A lean
mixture causes the chain oil tank to empty before the
fuel tank.
Use the recommended cutting equipment. A guide
bar that is too long will use more chain oil.
WARNING: Do not use waste oil! Waste oil
is dangerous to you and the environment.
Waste oil also causes damage to the oil
pump, the guide bar and the saw chain.
WARNING: Deficiente lubrication of the
cutting equipment can cause the saw chain
to break, which can cause serious injury or
death.
fully mixed.
321 - 004 - 27.09.2017