Domo DO720K Mode D'emploi page 43

SETTINGS
There are different ways to set the unit to your likings. We recommend that you first try the unit with
the factory settings. If these are not to your liking, use the instructions in the instruction manual to
personalise the unit to your liking and align it to the coffee beans you want to use. Besides the settings,
the type and quality of the coffee beans influence the taste and intensity of your espresso.
Adjusting coarseness
There are number markings on the bean reservoir that indicate the coarseness of the ground coffee. There
are 30 settings. You have to adjust the coarseness and rotate the reservoir while the device is grinding. If
you rotate it while the unit is in standby mode, a bean might get into the grinder and stop it.
First, try the coarseness at position 15 and taste the coffee. You can then adjust the coarseness based on
this taste. A grinding coarseness that is too fine gives the coffee a bitter taste. If it is too coarse, the coffee
will be weak and watery.
Rotate the reservoir clockwise for finely ground coffee. The finest grind is indicated by 0. Rotate the
reservoir anticlockwise for coarsely ground coffee. The coarsest grind is indicated by 30.
Setting grinder volume
You can set the amount of ground coffee for the grind button to your personal
preference. The standard setting is 7 seconds. The amount of ground coffee you make
depends on the type of bean and the coarseness setting.
Press and hold the grind button. Grinding will start. Release the button when you have
achieved the desired amount of ground coffee. The new amount of ground coffee for
the grind button is now set.
! Note: the minimum grind time is 5 seconds. If you grind for less than 5 seconds, the
unit will not record that as the new amount. The standard factory setting will be retained.
Setting coffee volume
You can adjust the amount for the single and double buttons to between 20 ml and 250 ml.
1. Press and hold the button that you want to set the volume (single or double).
2. The preparation starts and the indicator lamp for the selected button will light up.
3. When you obtain the desired amount, release the button. The preparation stops and you will hear an
alert, which indicates that the amount is set as the new volume for the button.
www.domo-elektro.be
2
1
GRIND
43
DO720K