Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.1. Prior to Installation
Prior to installing the heater, read all the instructions
for installation (figure 7), as well as checking the fol-
lowing points:
The heater volume should be suitable for the
•
sauna room volume. Table 2 shows the mini-
mum and maximum volumes for each heater
output. A precondition for the given values is
that the sauna room is well heatinsulated.
Walls and ceiling are covered with wood panel.
Check that supply voltage and amperages are
•
avaible for the heater.
The breakers and the connection cables con-
•
form with valid regulations and their dimen-
sions are in accordance with table 3.
The location is suitable for the heater ( 3.2.).
•
Note! Only one electrical heater may be in-
•
stalled in the sauna room. Multiple heaters can
Heater
Output
kW
HL(S)7U1/
6,8
HL(S)7U3
HL(S)9U1/
9,0
HL(S)9U3
HL(S)11U1/
10,5
HL(S)11U3
Table 2.
Installation details of the heater
Main Electrical Panel
Note: Control panel and power unit must be installed in a dry
place; away from spa, pool or shower; not outdoors. A
receptacle shall not be installed inside the sauna room.
Load Center
Load center shall be supplied
by electrical contactor during
field wiring. Load center can
be located in other serviceable
places, as well as location
shown on this diagram.
Figure 5.
Sauna control / Minimum safety distances / Installing the temperature sensor
8
3. INSTRUCTIONS FOR INSTALLATION
Dimensions
Width/Depth/
Weight
Height
inch
mm
lb/kg
16/13/33
50,7
415/340/840
16/13/33
50,7
415/340/840
16/16/33
55,1
415/410/840
Control Panel
Power Unit
EN
be installed and used in the sauna room only if
they share the same control unit (Multidrive)
3.2. Place and Safety Distances
The minimum safety distances are described in
figure 3 and 5.
It is absolutely necessary to install the heater
•
according to these values. Neglecting them
causes a risk of fire.
Hot pieces of stone can damage floor coverings
•
and cause a risk of fire. The floor coverings of
the installation place should be heat-resistant.
3.3. Heater fence
It is necessary for safety and should be constructed
of softwood to match sauna interior. See figures
3 and 5 for clearances from sauna heater. Fence
should be attached to wall and should not be placed
higher than top of heater below rock line.
Stones
Sauna room
Cubic vol.
2.3.!
max.
min.
lb/kg
CuFt/m³
23
110
50
177 5
110
50
23
177 5
25
154 70
177 5
4"
100mm
Sensor
B
A
A
min.
2,8''/70mm
SEAL TIGHT CONDUIT
90°C WIRE
Floor Area
Height
max.
min
max
CuFt/m³
sqft
sqft
354 10
28
57
75 1900
494 14
79
75 1900
28
635 18
28
102
75 1900
4"
100mm
inch
A
B
42
B
A
min.
inch/mm
mm
2
50
1060
A
A
A
Publicité
Table des Matières
Dépannage
