Sony DSR-50 Mode D'emploi page 26

Location and Function of Parts
• The superimposed data output to the LCD monitor
and the VIDEO OUT1 are the same. You cannot
display a different superimposed data.
• The adjustment of VIDEO LVL on the VIDEO SET
menu does not affect the VIDEO OUT1 output and
return signal to the camera.
• If the unit is externally synchronized, jitters may
appear in the VIDEO OUT1 connector output and the
LCD monitor image because the sync signal
frequency and the burst signals are not synchronized.
If the unit is externally synchronized, use the VIDEO
OUT2 connector. If you use the VIDEO OUT1
connector, set EXT SYNC on the VIDEO SET menu
to OFF.
2 INPUT SELECT selector
You can select DV, VIDEO, S VIDEO or CAMERA
to input the signals. The selected input is displayed on
the TC screen of the LCD monitor.
Notes
• When inputting signals from the DV IN/OUT
connector, the following settings are disabled:
– Video input level
– Audio input selectors (CAM/LINE/+48V ON)
– Audio input level control selectors (–60/–20/+4)
– Audio recording level
– Audio recording mode (AUTO/MANU)
– Audio mode (32 kHz/48 kHz)
– Audio AGC (Auto Gain Control)
– Wind noise reduction
– Audio limiter
– You cannot display the color bars.
• If you change this selector, the screen may
momentarily become bright or noise may appear.
This noise will be recorded.
26
(GB) Chapter 1 Overview
3 SUPERIMPOSE switch
Turn on this switch to superimpose text data onto the
output from the VIDEO OUT1 connector.
Note
The return signal to the camera is the same as the
output from the VIDEO OUT1 connector.
4 S VIDEO IN/OUT connectors (4-pin)
Inputs/Outputs the S-video signal with separated Y
(luminance) and the C (chroma: 3.58 MHz for DSR-50
and 4.43 MHz for DSR-50P).
5 VIDEO/REF.IN (reference input) connector
(BNC-type)
Inputs composite video signals to this unit. When
performing a playback synchronized with the external
sync signal, this connector inputs reference video
(black burst) signal.
6 VIDEO OUT2 connector (BNC-type)
Outputs composite video signals. The text data is not
superimposed.
7 COMPONENT OUTPUT Y, R-Y, B-Y
connectors (BNC-type)
Outputs component video (Y, R-Y, B-Y) signals.