Features Menu; Power Saving - Sony ESPRIT TAV-L1 Mode D'emploi

Features menu

Features

Power Saving

Light Sensor
AV2 Output
PC Adjustment
Select:
You can select the options listed below on the
Features menu. To select options, see "Navigating
through menus" (page 38).
Power Saving
Reduces the power consumption of the system.
1
Press (OK) to select [Power Saving].
2
Press M/m to select [Reduce], then press
(OK).
• [Standard]: Default settings.
• [Reduce]: Reduces the power consumption of
the TV.
• [Picture Off]: Switches off the picture. You can
listen to the sound with the picture off.
Light Sensor
Automatically optimizes the picture settings
according to the ambient light in the room.
1
Press (OK) to select [Light Sensor].
2
Press M/m to select [On] then press
(OK).
AV2 Output
Sets a signal to be output through the socket labelled
/ 2 on the rear of the system. If you connect a
VCR or other recording equipment to the
socket, you can then record from the equipment
connected to other sockets of the system.
1
Press (OK) to select [AV2 Output].
2
Press M/m to select one of the following,
then press (OK).
1
• [D-TV]* : Outputs a digital broadcast.
2
• [A-TV]* : Outputs an analogue broadcast.
42
GB
Standard
On
D-TV
Set: Back: End:
OK MENU
/
• [AV1]: Outputs signals from equipment
connected to the
• [AV4]: Outputs signals from equipment
connected to the
• [Auto]: Outputs one of the signals above.
*1 Note that this function may not be available in some
countries.
*2 Note that [TV] may appear in some countries.
PC Adjustment
Customizes the TV screen as a PC monitor.
1
Press
2
Press M/m to select one of the following,
then press
• [Phase]: Adjust the screen when a part of a
displayed text or image is not clear.
• [Pitch]: Enlarges or shrinkes the screen size
horizontally.
• [H Center]: Moves the screen to the left or to the
right.
• [V Center]: Moves the screen up or down.
• [Power Saving]: Turns to standby mode if no PC
signal is received.
• [Reset]: Resets to the factory settings.
Tip
This option is only available if you are in PC Mode.
Note
When "AUTO" in "Lift Mode" and "On" in "Power
Saving" is selected, the lift unit moves up automatically
if the system enters standby mode.
2
/ 1 socket.
4/ 4 socket.
(OK) to select [PC Adjustment].
(OK).