Set Up
6
Auto Startup (44)
Language (44)
Country (44)
Auto Tuning (44)
Programme Sorting (44)
Programme Labels (45)
AV Preset (45)
– Label/Skip/Sound Offset
Manual Programme Preset (46)
– Programme/System/Channel/Label/AFT/Audio
Filter/Skip/Decoder/ATT/Confirm
Digital Set Up* (48)
– Digital Tuning/Digital Set-up
Note
The options you can adjust vary depending on the situation.
Only the options that can be operated are displayed.
* Note that this function may not be available in some countries.
Picture Adjustment
menu
Picture Adjustment
Picture Mode
Contrast
Brightness
Colour
Hue
Sharpness
Backlight
Colour Tone
Reset
Noise Reduction
Select:
Set:
You can select the options listed below on the Picture
Adjustment menu. To select options, see "Navigating
through menus" (page 38).
Tip
When you set [Picture Mode] to [Vivid] or [Standard], you
can adjust only [Contrast], and [Reset].
Picture Mode
Selects the picture mode.
1
Press
(OK) to select [Picture Mode].
2
Press M/m to select one of the following
picture modes, then press
• [Vivid]: For enhanced picture contrast and
sharpness.
• [Standard]: For standard picture. Recommended
for home entertainment.
• [Custom]: Allows you to store your preferred
settings.
Tip
You can also change the picture mode by pressing
repeatedly.
Contrast/Brightness/Colour/Hue/
Sharpness/Backlight
1
Press
(OK) to select the option.
2
Press </, to set the level, then press
(OK).
Tip
[Hue] can only be adjusted for an NTSC colour signal
(e.g., U.S.A. video tapes).
[Brightness], [Colour], [Hue], [Sharpness] and
[Backlight] only appear and can be adjusted if [Picture
Mode] is set to [Custom].
Custom
Max
50
50
0
15
5
Warm
Auto
Back:
End:
OK
MENU
(OK).
Continued
39
GB