Installation; Wall Mounting; Heater Installation; Power Supply - Stiebel Eltron CK 150-1 Trend Manuel D'utilisation Et Installation

INSTALLATION

Installation
11. Installation
DANGER: Electrocution
If installing the heater in rooms with a bath and/or
shower, take the relevant safety zone into account in
accordance with the information on the heater type
plate.
Install the heater in such a way that switching and
control equipment cannot be touched by a person in
the bath or shower.
WARNING: Fire
Only fit the heater to a vertical wall that is heat-resis-
tant to at least 194°F (90°C).
Maintain minimum clearances to adjacent surfaces.
Never install the heater directly below a wall socket.

11.1 Wall mounting

NOTE:
Secure the wall mounting bracket with the tab cut-out
pointing upwards.
NOTE:
Use appropriate fastening materials.
1 Wall mounting bracket
Mark out the holes to be drilled for the wall mounting brack-
et on the wall. Use the wall mounting bracket as a template
for this purpose.
Drill the holes.
Secure the wall mounting bracket horizontally to the wall
with suitable rawl plugs and screws.
NOTE:
The horizontal and vertical slots enable an adjustment
in case the fixing holes are not quite where they
should be.
6 | CK 150-1 / 200-2 Trend

11.2 Heater installation

1 Wall mounting bracket
Hook the heater with the upper vertical recesses of the back
panel onto the wall mounting bracket.
1
1
2
1 Through-hole for locking screw
2 Locking screw
Mark out the hole to be drilled for the locking screw. Use the
through hole in the lower section of the heater casing as a
template for this purpose.
Remove the heater from the wall mounting bracket.
Drill the hole for the locking screw. Insert a suitable rawl
plug.
Hang the heater as described on the wall mounting bracket.
Secure the heater with a suitable screw.

11.3 Power supply

WARNING: Electrocution
Carry out all electrical connection and installation
work in accordance with relevant regulations.
MATERIAL LOSSES:
!
The specified voltage must match the mains voltage.
Observe the type plate.
1
www.stiebel-eltron-usa.com