Setting The Gas Grill; Cleaning The Accessories; Setting The Hob; Advance Cleaning Of Burner Cup And Cap - Bosch HGA23A1 0S Série Notice D'utilisation

Setting the gas grill

Open the top cover. The top cover must remain open for as
1.
long as the cooker is in operation.
Turn on the main gas supply to the appliance. Insert the plug
2.
into the socket.
Insert the protecting plate into the groove below the control
3.
panel.
Insert the protecting plate with the longer edge at the front
and the curvature at the bottom.
Secure the protecting plate in the groove below the control
panel using the retainers.
Ensure that the protecting plate is engaged in the retainers. If
the protecting plate cannot be pulled out, it is engaged
correctly. You can now safely use the protecting plate. If it
can be removed, insert it into the groove at a slightly higher
angle and make sure that it engages in the retainers.
Close the oven door so that it is as close as possible to the
4.
protecting plate.

Setting the hob

Your hob is equipped with three gas burners and one hotplate.
The following information explains how to light the gas burners
and set the hotplate.

Advance cleaning of burner cup and cap

Clean the burner cap (1) and cup (2) with water and washing-
up liquid. Dry the individual parts carefully.
Place the burner cup and cap back on the burner shell (5).
Ensure that the igniter (3) and flame safety pin (4) are not
damaged.
The nozzle (6) must be dry and clean. Always position the
burner cap exactly over the burner cup.

Igniting the gas burners

Always position the burner cap exactly onto the burner cup. The
openings in the burner cup must remain unobstructed at all
times. All parts must be dry.
Open the upper cooker cover. The upper cover must remain
1.
open whilst the cooker is in operation.
Turn the control for the required hotplate anti-clockwise to the
2.
symbol with the large flame
32
— .
Push in the function selector and turn it clockwise to the grill
5.
setting .
(
Keep the function selector pressed in and press the ignition
6.
button at the same time.
8
The gas coming from the gas grill is ignited using the ignition
7.
button. Keep the function selector pushed in for 10 seconds
so that the safety pilot starts up.
Check whether the flame is lit. If the flame goes out, repeat
8.
the process from step 5.
Switch off the function selector after 30 minutes. Once the
9.
oven has cooled down, remove the protecting plate.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.

Cleaning the accessories

Before you use the accessories for the first time, clean them
thoroughly with hot soapy water and a soft dish cloth.
With the hotplate control pressed in, press the ignition button.
3.
Gas begins to flow out and the gas burner ignites.
Press and hold the hotplate control for 1-3 seconds. This
4.
activates the safety pilot. If the gas flame goes out, the gas
supply is automatically cut off by the safety pilot.
Set the required flame size. Between the Off
5.
— setting, the flame is not stable. Therefore, always choose a
setting between the large flame
If the flame goes out again, repeat the process from step 2.
6.
To finish cooking, turn the hotplate control clockwise to the
7.
Off position.
û
The hotplate control should not be turned to the ignition
position for longer than 15 seconds. If the burner does not light
within 15 seconds, wait at least one minute. Then repeat the
ignition process.
The gas burner does not ignite
If there is a power cut or if the ignition plugs are damp, you can
light the gas burners with a gas lighter or a match.
û setting and the
— and small flame ˜ .