Velleman CAMCOLD26 Mode D'emploi page 10

AREA NO 0–7
7.11 Motion Detection
Use this function to see motion detection during live monitoring. You
can define up to 4 separate areas for motion detection. If the camera
detects motion in an area, the outer edge of that area will 'flash'.
Menu: DIRECTION
SENSITIVITY
V. 01 – 09/01/2015
CAMCOLD26/CAMCOLD26W
To define up to 8 areas. Select the desired area and
use the settings below.
 STATUS: select ON to activate the selected
masked area; select OFF to deactivate the
selected masked area.
 HORIZON SIZE:
set the width [a]
(in pixels) of the
masked area.
 VERTICAL SIZE:
sets the height [b]
(in pixels) of the
masked area.
 HORIZON MOVE:
sets the distance
(in pixels) from the
left side of the
screen [c] for the
masked area.
 VERTICAL MOVE:
sets the distance
(in pixels) from the
top of the screen
[d] for the masked
area.
Set the motion detection sensitivity. With a higher
sensitivity, slighter movements will be detected.
Available options for sensitivity: WEAK (weak);
LOW (low); MIDDLE (medium), and HIGH (high).
10 ©Velleman nv